Connect 3" NPT (National Pipe Taper) to 2-1/2" NPT (National Pipe Taper)

Stepping a 3-8 NPT port down to a 2-1/2-8 NPT fitting uses a NPT (ASME B1.20.1) reducing bush: a male 3-8 NPT on the outside and a female 2-1/2-8 NPT inside, both to the same NPT form so they seal on the thread flanks with PTFE tape. The major diameter goes from 88.9 mm at 3-8 NPT to 73.02 mm at 2-1/2-8 NPT. This is a single stocked reducing part; the step is one nominal size.

Both ends are the same NPT standard, so the only thing that changes is the size; do not swap standards at the same time. If you need to cross to a different thread form as well, add the correct thread adapter rather than forcing a same-standard reducer to do two jobs.