Connect 2-1/2" NPT (National Pipe Taper) to 2" NPT (National Pipe Taper)

Stepping a 2-1/2-8 NPT port down to a 2-11.5 NPT fitting uses a NPT (ASME B1.20.1) reducing bush: a male 2-1/2-8 NPT on the outside and a female 2-11.5 NPT inside, both to the same NPT form so they seal on the thread flanks with PTFE tape. The major diameter goes from 73.02 mm at 2-1/2-8 NPT to 60.32 mm at 2-11.5 NPT. This is a single stocked reducing part; the step is one nominal size.

Both ends are the same NPT standard, so the only thing that changes is the size; do not swap standards at the same time. If you need to cross to a different thread form as well, add the correct thread adapter rather than forcing a same-standard reducer to do two jobs.